Epson Home Cinema 8350 Projector - Physical Tour-1

Posted on October 6, 2010 by Art Feierman

The Advanced sub-menu in the Image menu, offers all the control any "tweaker" would want.

The three options here, are a Gamma menu, which lets you select from 5 preset gamma's including the "ideal" 2.2 gamma.

You can also create your own gamma curve, essentially the equivalent to an audio equalizer, but it lets you control the relative brightness separately of the darkest, more moderate and brightest areas, with a total of 9 separate brightness bands.

For adjusting white balance (grayscale calibration), the RGB sub-menu gives you lots of control, with separate bias and offset for each of Red, Green, and Blue.

The even more sophisticated RGBCMY submenu allows you to control the color balance individually for the three primary (red, green, and blue), and secondary (cyan, magenta, and yellow). A moment to explain. Using the RGB menu, you can adjust the projector to as close as possible to the ideal 6500K temperature for movie watching. Even if you get that perfect, it doesn't guaranty that individual colors are right on the money. For example Red, could still look a little to orangish (which means it has some yellow content), and so on. With this control, you can adjust the individual colors, and even their intensity (saturation).To do this properly you need some good equipment, or an artist's eye and understanding of color. The Signal menu controls aspect ratio, Noise reduction, Overscan control (Output Scaling) and noise reduction.

Speaking of color temperatures, the Absolute Color Temp control offers a slide bar so you can move the color temp up or down by increments of 500K (Kelvin)

Moving to the Settings Menu, from here you have a lot of control of the hardware, including a Sleep mode, password protection (Child Lock), control of the Trigger for raising and lowering properly equipped, motorized screens. You can also set the projector for front projection, rear, ceiling mount or tabletop.

The Info Menu (not shown, tells you about the signal source, lamp hours, etc. There are no controls on that menu.